Code-correct outdoor lighting wiring, installed by licensed electricians
Landscape Lighting Installation Findlay OH Built to Last
Landscape Lighting Installation Findlay OH is what we do best. If your path lights flicker, your transformer hums, or you want new landscape lighting Findlay OH that survives Ohio winters, our licensed electricians run the circuits, set the fixtures, and test every connection before we leave. We serve homeowners across Hancock County and the 45840 ZIP, and we show up when we say we will.
Live phone supportUpfront optionsBacked workmanship
What's included
What Our Landscape Lighting Installation Includes
Every install starts with a walkthrough and ends with a tested, labeled circuit. Here is what is covered on a standard job, and what we quote separately if your panel or wiring needs attention first.
Fixture Layout and Aiming
We flag every fixture location with you, space path lights 6 to 8 feet apart, and aim each one after dark so the light lands on the walkway, not in your windows. You approve the layout before we trench.
Transformer and Circuit Sizing
We calculate total wattage, size the transformer to run at 80 percent load, and confirm your panel has capacity. If it does not, we quote a dedicated circuit or panel work as a separate line item so you see the full picture.
Trenching and Direct-Burial Cable
We trench 6 to 8 inches deep, run direct-burial cable or THHN wire in conduit, and leave service loops at each fixture. Cable staples hold the run, and we backfill and rake the trench lines when we are done.
Waterproof Connections
Every splice lands in a junction box above grade with wire nuts and electrical tape. We test each connection with a voltage tester as we go, so a bad splice never gets buried under six inches of Findlay clay.
GFCI Protection and Breaker Labeling
Outdoor circuits get GFCI protection at the source, and we label the breaker clearly in your panel. We test the GFCI with a tester and confirm the circuit holds under full load before we pack up.
Service overview
Landscape Lighting Installation Findlay OH Done Right
Landscape Lighting Installation Findlay OH is the work of running low-voltage or line-voltage circuits from your panel or transformer to fixtures buried along paths, garden beds, and driveways. We pull THHN wire or direct-burial cable through conduit, set junction boxes above grade where they stay dry, and land every connection with wire nuts and electrical tape so water never finds a loose splice. A multimeter and voltage tester confirm the load before we backfill.
Findlay homeowners call us for a few reasons. Older homes around South Main and College Hill have outdoor outlets that trip a GFCI the moment it rains. New builds out near Cedar Creek often come with a single porch light and nothing else. If you need landscape lighting replacement Findlay, we can swap tired fixtures and corroded transformers without tearing up the whole yard. The cost to install landscape lighting in Findlay OH depends on run length and fixture count, but most jobs land in a predictable range.
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.
The service timeline
How Our Landscape Lighting Installation Works
The process flexes to the condition, but these checkpoints keep decisions clear.
Walkthrough and Layout
We walk your yard with you, note the trees, beds, and walkways you want lit, and mark fixture locations with flags. We check your panel for an open breaker slot and confirm whether we are running a new dedicated circuit or tying into an existing outdoor outlet. This takes 30 to 45 minutes.
Circuit and Transformer Sizing
We calculate the total wattage of your fixture plan and size the transformer to run at 80 percent load. If the run exceeds 100 feet, we step up to 12-gauge wire to prevent voltage drop. We use a circuit breaker finder to label the breaker correctly before we touch anything.
Trenching and Wire Pull
We trench 6 to 8 inches deep along the fixture path, pull direct-burial cable or THHN wire through conduit, and leave slack at each fixture stub. Cable staples and conduit hold the run in place. Most residential yards take one day for trenching and wire pull.
Fixture Setting and Connections
We set each fixture, strip the wire with wire strippers, and land connections inside waterproof junction boxes. Every splice gets wire nuts and electrical tape. We test each fixture with a voltage tester as we go, so we catch a bad connection before the trench is closed.
Testing and Cleanup
We energize the system, check the transformer load with a multimeter, and verify GFCI protection at the source. We aim each fixture, rake the trench lines, and walk the yard with you. Total install time for a typical Findlay home is one to two days.
Tools & methods
Tools and Methods We Use
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Fluke Multimeter
Measures voltage at the farthest fixture so we can confirm voltage drop stays under 3 volts on long runs.
Voltage Tester
Confirms each fixture connection is live before we backfill, so a bad splice never gets buried.
Wire Strippers and Cable Ripper
Clean strips on THHN and direct-burial cable mean tight connections and no nicked conductors.
Conduit Bender
Forms sweeps and offsets in PVC conduit where the run crosses a walkway or comes up a wall.
GFCI Tester
Verifies that outdoor receptacles trip and reset correctly after installation.
Circuit Breaker Finder
Labels the correct breaker before we work, so the panel stays accurate for the next electrician.
Klein Tools Hand Tools
Daily drivers for terminating, tightening, and testing on every outdoor circuit we touch.
Use cases
When Findlay Homeowners Call Us for Lighting
These examples show how the service framework adapts rather than forcing every call through one repair.
Flickering System Repaired, Not Replaced
A South Main home had 9 existing fixtures that flickered whenever the air conditioner started. The transformer hummed and the breaker tripped about once a week. → We measured 4.1 volts of drop at the farthest fixture, stepped up to 12-gauge wire on the long run, and replaced the undersized transformer. Flicker stopped and the breaker has held for months.
Winter Storm Damage Restored Same Day
A fallen branch pulled a run out of the ground near Riverbend, shorting the circuit and tripping the breaker. The homeowner had no path lighting and no porch light. → We isolated the damaged section with a circuit breaker finder, replaced 22 feet of direct-burial cable, and set a new waterproof junction box. Power was restored the same day, and we re-aimed the two fixtures that had shifted.
Problems we solve
Outdoor Lighting Problems We Solve in Findlay
Most outdoor lighting failures trace back to water, loose connections, or a transformer running over capacity. We diagnose with meters, not guesses.
Path lights flicker or dim when the AC kicks on
We measure voltage at the farthest fixture with a multimeter. If the drop is more than 3 volts, we step up to 12-gauge wire or split the run onto a second transformer tap. Flicker stops, and the transformer runs cooler.
GFCI trips every time it rains
We inspect the box for water intrusion, replace the GFCI with a weather-rated device, and re-terminate the wires. If the splice behind the box is corroded, we cut it back and land a fresh connection in a sealed junction box.
Transformer hums loudly or feels hot
We calculate the actual load, replace the transformer with a correctly sized unit, and rebalance the taps. If the run is too long for one transformer, we add a second one closer to the far fixtures.
Half the fixtures stopped working after winter
We isolate the dead zone with a voltage tester, locate the break, and repair the run with direct-burial cable and a waterproof junction box. We also check the fixtures in that zone for cracked housings and replace what will not survive another winter.
Pricing process
Landscape Lighting Installation Pricing
$1,800 - $4,500 for a full system; $250 - $650 for transformer replacement or repair
Fixture count and type
Path lights run less than uplights or well lights. A 8-fixture path package sits near the low end, while a 16-fixture design with brass uplights pushes toward the top of the range.
Trench length and soil
Long runs need more cable and more labor. Findlay clay slows hand-digging, and rocky or root-heavy yards take longer than open ground near Cedar Creek.
Transformer size
A 150-watt transformer costs less than a 300-watt or 600-watt unit. We size to the load plus headroom, so you are not paying for capacity you will never use.
Customer reviews
What Findlay Customers Say
★★★★★
“Our old transformer hummed so loud you could hear it from the porch, and half the path lights were dead. The crew traced it to a corroded splice in a junction box that had been buried wrong. They re-ran the wire in conduit, set a new transformer, and added two uplights on the maple. Yard looks great and the breaker has not tripped once.”
★★★★★
“We moved into a new build with one sad porch light. They mapped out 12 fixtures, trenched in a day, and had everything aimed by the next afternoon. What sold me was the labeled breaker and the zone map they left behind. When I wanted to add two fixtures near the fire pit, I knew exactly which run to tap.”
★★★★★
“Our outdoor outlet tripped the GFCI every time it rained, which killed the landscape lights. They replaced the outlet, sealed the box, and found a loose wiring connection inside the transformer. It was not the big job I feared. Fair price, and they tested everything with a meter before they left.”
How much does landscape lighting installation cost in Findlay OH?
Most residential jobs run $1,800 to $4,500 in 2026, depending on fixture count and run length. A basic 8-fixture path lighting package with a new transformer and dedicated circuit starts near $1,800. Larger systems with uplights, a longer trench, or a panel upgrade push toward the top of that range. We give you a flat number before we dig.
Can you install landscape lighting in winter in Findlay?
Yes, as long as the ground is not frozen solid. Findlay frost typically sets in from late December through February, and trenching frozen ground is slow and expensive. We schedule most winter installs as fixture swaps, transformer replacements, and indoor panel work. If you want a full new system, late fall and early spring are the best windows.
How long does landscape lighting installation take in Findlay?
A typical 8 to 14 fixture system takes one to two days. Day one is trenching, wire pull, and transformer mounting. Day two is fixture setting, connections, aiming, and testing. If we are adding a dedicated circuit from the panel, add two to three hours. Same-day landscape lighting installation Findlay is possible for simple transformer swaps.
What type of landscape lighting is best for Findlay homes?
Low-voltage LED systems with brass or copper fixtures hold up best here. They handle freeze-thaw cycles, draw 3 to 9 watts per fixture, and run on a 12-volt transformer that is safe to service. For driveways and long runs, we sometimes use line-voltage fixtures on a dedicated circuit. We match the system to your yard, not the other way around.
Related services
Related Services
New Circuit Installation
Landscape lighting often needs its own circuit so a tripped breaker does not kill your porch lights too. We run a dedicated circuit from your panel to the transformer, size the wire for voltage drop, and label the breaker so future work is simple.
Electrical Rewiring
If your outdoor outlet is fed by old wiring, a new lighting system will inherit the same problems. We replace worn runs with Romex cable or THHN in conduit, fix loose wiring connections, and bring the circuit up to NEC standards before we add fixtures.
Whole Home Rewiring
Homes around Downtown Findlay with cloth or aluminum wiring often cannot safely carry a new outdoor load. Whole home rewiring brings the panel and branch circuits up to date, which makes a landscape lighting installation in Findlay, Ohio straightforward instead of a workaround.Ready when you are
Get Your Landscape Lighting Installation Findlay OH Quote
Licensed, insured, and code-correct on every outdoor circuit. Call +14197996088 and we will walk your yard, size the transformer, and give you a flat number before we dig. Same-day slots are often available.
Talk with the local team
Request Landscape Lighting Installation
Reach out for a free estimate on New Circuit Installation & Rewiring Findlay OH. We answer calls 24/7 for emergencies and schedule regular work Monday through Friday. Our office is in Findlay, and we serve all of Hancock County. Call, email, or stop by.